Need extra light shining on the side of the trails? Made of sturdy powdercoated 11ga steel, the HRG Offroad light kit allows you to mount a pair of LED pod lights in the perfect spot. Bolts to existing hood hinge bolts. No drilling necessary. This kit includes two (2) HRG Offroad 2 inch LED pod light set. Compact, but powerful 2 Inch LED light pods producie a total of 1,800 lumens.
Fits: 2017-2023 Mazda CX-5
- Mounting brackets spefically for 2017-2023 Mazda CX-5 (ALL MODELS)
- 2 Inch Off-road Led Round Lights (Pair)
Stainless steel hardware
- Wiring harness
- Power switch
- 40A relay
- installation instructions
Each of these lights is equipped with one 10 watt USA made Cree LED chips that produce a spot beam pattern.
IP69K guarantees product is 100% sealed to foreign contaminants and survive the harshest elements. The housing is constructed of high quality 6063 aluminum and sealed with 316 stainless steel screws every 1.5 inches to ensure an impenetrable seal. This construction is what gives the lights the IP69K rating which means these lights will survive the harshest elements you can throw at them. The lens is crafted from high quality GE Lexan which is 300 times stronger than glass! Plus it is resistant to corrosive acids and other chemicals such as gasoline. The lens is also manufactured to be scratch resistant and UV resistant. The lights are equipped with a special breather apparatus that is uniquely designed to prevent condensation and water intrusion. They are also equipped with a Deutsch connector which is globally renowned for its ability to be waterproof and its ease of use. To prevent unwanted wind noise, Wind Reducers are equipped to ensure a quiet experience during high speed travel. Outdoor Dupont painting coats the housing guaranteeing the housing will remain unchanged for 5 years. The interior of these lights is unique because they are all made with Cree LED chips (Made in the USA) which allow for low forward voltage, low heat generation, long life and high ESD tolerance and resistance. The PCBA (Printed Circuit Board Assembly) is engineered with unique temperature protection, voltage protection and current protection designs to maximize efficiency and increase durability. This unique design means no electromagnetic interference with other nearby electronics on your vehicle. Lastly as an added measure, an over voltage protection is installed prevent premature failure from accidental voltage fluctuations.
DITCH LIGHT BRACKETS MADE IN U.S.A.